| January 13, 2016
  1. The SCR in Figure 1 below requires a 3 V trigger. Using Multsim, design a system by which the gears are shifted when a CdS photocell resistance drops below 4k.


    Figure 1

  1. Using Multisim, design a system by which a control signal of 4 to 20 mA is converted into a force of 200 to 1000N. Use a pneumatic actuator and specify the required diaphragm area if the pressure output is to be in the range of 20 to 100kPa. An I/P converter is available that converts 0 to 5 V into 20 to 100 kPa. A block diagraph of the system is shown below. (Hint: Use a differential amplifier. You are only designing the circuit to interface into the I/P below)

Get a 5 % discount on an order above $ 150
Use the following coupon code :
Discuss at least three very important characteristic of differential amplifiers. What do the terms inverting and non-inverting mean in the context of amplifiers? Calculate the ideal IT, IE, Vc for the differential amplifier shown in the diagram
week 6

Category: Homework Help

Our Services:
Order a customized paper today!
Open chat
Hello, we are here to help with your assignments